Falc Italian made agricultural machinery includes rotary hoes to 350hp and shredders and mulchers to 400hp for full strength farming in Australia.

Falc Farm Machinery

Pellicano Special 50-80 hp Verge Mower


Falc Pellicano Special Verge Mower (Left Hand Offset)

Photograph for illustration purposes - standard specifications may not match those shown.

  • Rear, 3pt linkage, clevis mounted
  • Left hand offset (Right hand offset is available on request)
  • 540 rpm PTO
  • Rotor speed: 2,278 rpm. Hammer tip speed: 43m/sec
  • Drive shaft with 1 3/8” 6 spline yoke
  • Side drive: 4 x SPB ‘V’ belts
  • 80hp gearbox fitted with an internal free wheeling clutch
  • NB: On request the gearbox may be mounted on the outside of the frame to enable greater reach
  • 4mm body plate
  • Mechanical break-back device with automatic re-set for protection when an obstacle is encountered
  • Height control via rear roller, braced by a rigid steel bar
  • Rear roller tube: ∅139.7mm x 4mm
  • Rotor tube: ∅139.7mm x 10mm & dynamically balanced
  • Hydraulic adjustment of both tilt and offset
  • Rear, adjustable door
  • Easily greasable pivot points
  • Hammer flails secured with 25mm diameter pins & self-locking nut
  • Operating angles from 55 degrees down to 90 degrees up
  • Full CE safety guarding

SPECIFICATIONS

PEL SPECIAL 1600
PEL SPECIAL 1800
Working Width (m)
1.67
1.81
Transport Width (m)
1.82
1.96
No. of Flails
22
24
Weight (kg)
600
620
Tractor Power (hp)
50-80
55-80

BROCHURE

Click this link to download a brochure.
Please note that Australian specifications may vary to those shown on the manufacturer's brochure and website.
Follow this link to the  manufacturer's website (Falc)

Disclaimer: Specifications and features described on the website are subject to change without notice. All care has been taken to present accurate information, however, the company is not liable for unintended errors or omissions.