Photograph for illustration purposes - standard specifications may not match those shown.

• Rear, 3pt linkage, clevis mounted; Cat 2
• Left hand offset (Right hand offset is available on request)
• 150hp gearbox fitted with an internal free wheeling clutch
• 540 rpm PTO
• Drive shaft with double constant velocity joint & 1 3/8” 6 spline yoke
• Side drive: 4 x SPB ‘V’ belts
• 4mm body plate with 25mm wear and tear sheet
• Tractor requires dual hydraulic remote couplings
• Hydraulic adjustment of both tilt and offset/li>
• Rear, closable door
• Height control via Rear Roller, braced by a rigid steel bar
• Rear roller tube: ∅168mm x 5mm
• Rotor tube: ∅1937mm x 8mm & dynamically balanced
• Rotor & Rear Roller bearing housings fabricated from machined steel
• Mechanical break-back device with automatic re-set for protection when an obstacle is encountered
• Pivot points fitted with self-lubricating bushes
• Headstock dimensions: 120 x 80 x 10mm on the 1600; 120 x 120 x 10mm on 1800 & 2100
• Hammer flails secured with 25mm diameter pins
• Operating angles from 60 degrees down to 90 degrees up
• Minimum tractor weights: 2,500kg (1600 model); 2,700kg (1800 model) & 2,900kg (2100 model)
• Minimum tractor wheel track: 1.6m (1600 model); 1.8m (1800 model) & 2.1m (2100 model)
• Full CE safety guarding

BROCHURE

Disclaimer: Specifications and features described on the website are subject to change without notice. All care has been taken to present accurate information, however, the company is not liable for unintended errors or omissions.